Longacre 56605 Spline Hub User Manual download pdf

WE DO NOT RECOMMEND WELDING HERE. If you do be sure NO

WELD comes up above these surfaces! Grind flush as needed. Welding

material on the steering shaft spline above the face of the hub where the wheel

is mounted may not let the hub to engage properly, allowing the wheel to come

off unexpectedly.

Use these bolts AND all

washers included.

Other bolts may thread into the body too far,

contact the release mechanism, and affect its operation.

After installed thoroughly check Quick Release operation. If it

does not release smoothly and easily check the bolt length,

welding of steering shaft spline, or anything else causing bind.

Check the operation each time you use it for proper connection.

WARNING!

If this quick release hub is not installed properly it could allow the

wheel to come off while on the track, possibly causing serious

injury or death. It is the installer’s responsibility to be certain the

hub is installed properly and will release properly after installation.

This steering shaft spline has an second safety engagement groove.

To put the wheel on pull the Disengagement Ring up toward the driver, align the splines, and push the

wheel & hub on until it bottoms. Release the Ring to lock. Pull Ring up to remove wheel.

weld

here

If you leave out either washer or

use a different bolt the hub may not

release properly!

8/07Disengagement Ring (pull up toward driver)

Disengagement Ring (pull up toward driver)